Vega WHA-GW-WIRELESSHART GATEWAY Manuel d'utilisateur télécharger pdf (Page 24)

221981 2011-07

WHA-GW-*

Installation

Pin assignment of the Ethernet plug

You do not need an Ethernet plug to connect the Ethernet cable to the Gateway. However,

you need an Ethernet plug at the other end of the cable to connect the cable to an Ethernet

hub, switch, router or PC.

There are different standards for Ethernet plugs: T568A and T568B (see following

figure/table). The only difference between these standards is that certain wires are

connected to different pins of the plug. It is not important which standard the plug uses.

But, depending on the plug standard, there are two different ways of connecting the other

end of the Ethernet cable to the Gateway.

Figure 3.7Pin assignment RJ45 plug

Pin assignment of a T568A/T568B plug

Note!

Tension relief and bending radii

Ensure sufficient relief of tension on the cables during installation and note the minimum

bending radii of the cables.

Signal RJ45 Pin Wire color T568A Wire color T568B

TX+ 1 white/green white/orange

TX- 2 green orange

RX+ 3 white/orange white/green

4 blue blue

5 white/blue white/blue

RX- 6 orange green

7 white/brown white/brown

8 brown brown

Table 3.1Pin assignment of a T568A and T568B plug

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 95 96

Pas de commentaire

Vega WHA-GW-WIRELESSHART GATEWAY Manuel d'utilisateur Page 24